How to use trough compost windrow turner correctly for Fermentation of Raw Materials

 How to use trough compost windrow turner correctly?

1. All rails of the compost windrow turner are required to be grounded for safety. The airport site for composting should be flat and solid. There should be no concave convex surface greater than 50 mm in the operation area. The length is not limited. The width should ensure the turning of the machine.
2. The width and height of raw fertilizer to be mixed shall not be more than 2000mm and 800mm respectively, and the stacking shall be linear.
3. When replacing trunking or cables, the power supply must be cut off.
4. When lifting the winch, attention must be paid to observation at any time, not only to prevent the roller from being too low to damage the blades, but also to prevent over pulling, which will damage the winch shaft and bearing seat. When part of the steel wire rope is broken or hairy, the wire rope shall be replaced in time.

Working process of small compost windrow turner:
The fermentation bed adopts the lower trough type, and cuts the cement tank from 1.6 meters (0.8-1.6 meters) from the high altitude. The width of the tank matches with that of the compost windrow turner. There are 4, 8 and 12 meters. Several fermentation tanks form the fermentation bed. The sun shed or steel shed is built under the fermentation bed to prevent rain. The wall adopts low wall, and the pipe is ventilated. The sunlight shed can improve the temperature and is beneficial to the fermentation bed. 

The automated production process of organic fertilizer equipment consists of a measuring device, a feeding device, and a control system to form an automatic processing system. During the production and processing of composite fertilizer, the automatic measuring device measures the processing size of the workpiece, compares it with the required size of the chicken manure granulator, and sends a signal. After the signal is converted and amplified, the production equipment is controlled to make corresponding adjustments until the specified production requirements are met, and the processing automatically stops.